Fibar Systems 300
Fibar Systems 300
Why Fibar System 300?
FibarSystem 300 is the preferred choice of schools, parks, architects, contractors, and landscapers—installed in over 15,000 playgrounds throughout the U.S. for three big reasons.
This patented system is composed of Fibar Engineered Wood Fiber, FibarFelt Geotextile, our exclusive FibarDrain drain strips plus FibarMat wear mats. No other recreational surfacing product provides a better combination of accessibility, safety, and superior drainage. All of these features come with an affordable system and an outstanding 25 year warranty.
The 3 Big Reasons
Gets Rid of Excess Rain Water
Just one inch of rainfall per hour drenches a typical 4,000 square-foot playground surface with 2,400 gallons of water. Which means one bad rainstorm could damage a sub-standard playground surface, requiring expensive repairs. What’s even worse, kids can’t play in a flooded playground.
Single-source Solution & Warranty
Simpler is better. FibarSystem 300 combines all the parts needed for an ideal playground surface. It’s soft enough to cushion falls. Firm enough for wheelchairs. And protected by built-in drainage and a 25-year Warranty.
Fibar System 300 Specifications
FibarSystem 300 is our premier playground surfacing product line for all uses including areas with high-to-average rainfall and/or poor drainage. The patented system is composed of Fibar Engineered Wood Fiber, FibarFelt Geotextile, exclusive FibarDrain drain strips plus FibarMat wear mats. No other recreational surfacing product provides a better combination of accessibility, safety, 25-year warrant, and superior drainage properties at a comparable cost.
Note: Depth measurements are approximate after compaction.
To help comply with the Federal Accessibility Law and to preserve your warranty, FibarMat wear mats must be installed under all swings, tire swings, slide exits, and all other wear areas, including sliding poles.
FibarSystem 300 Above-Ground Installation Detail
Entrance and exit ramps into the Fibar Engineered Wood Fiber should have a minimum slope of 1 in 12 or must meet current ADA, State or local regulations.
FibarSystem 300 In-Ground Installation Detail
Entrance and exit ramps into the Fibar Engineered Wood Fiber should have a minimum slope of 1 in 12 or must meet current ADA, State or local regulations.
Note: Diagrams are not to scale. For illustrations purposes only.
Call Us
(805) 668-3442